We guarantee hassel free installation

a three step process

How To Install

1.

Take ENERLYF attached with 4-core cable out of the box. Straighten the 4-core cable.

2.

Remove insulation from open end of the 4-core cable and connect four different cables as below:

2.1 YELLOW: Connect across Ceiling fan switch
2.2 YELLOW: Connect across Ceiling fan switch
2.3 RED: Connect with Live supply through available switch if any.
2.4 BLUE: Connect with Neutral through available switch if any.

3.

Fix the device on the wall (Above the switchboard) using provided double sided tape. User can hang on the wall using provided screws if required.

Note: Connect all wires tightly with no loose connections at all. To be handled by experienced electricians only. Don't try this on your own if you are not sure.

configure effortlessly

How To Configure

1.

Set preferred settings on your AC remote & Ceiling fan regulator. click here to see instructions for the same.

2.

Turn AC ON using your remote. Now do not press any button on your remote. Remote is ready to teach ENERLYF with the desired settings.

3.

Put ENERLYF in learning mode by pressing ON/OFF switch for 4-6 seconds

4.

ENERLYF display will show "L". Here "L" indicates that ENERLYF is in learning mode

5.

Wait till 'L' disappears on display.

6.

LED panel above display will start blinking.

7.

Direct your remote towards ENERLYF (Just like you point it towards AC to operate) and press "ON/OFF" button. (Note: Earlier in step #2, you have turned ON AC using remote. So in this step, remote will teach AC OFF signal to ENERLYF)



For detailed instructions


click here

NOTE: Steps #1 to #7.8 are to be followed in these use cases:


1. New device being switched on for the first time
2. If you would like to change the desired settings
3. In case you have replaced AC with newer one

IT'S EASY TO USE!

How To Use

1.

Power on ENERLYF by pressing ON button

2.

LED panel on the device will glow and ENERLYF will display "ELYF" for some time and it will disappear.

3.

ENERLYF will display current room temperature before initiating its operation and it will disappear. LED panel will remain ON during device working state.

4.

ENERLYF will serve you with comfortable sleep. You may go to bed

5.

On wake-up, power OFF ENERLYF.

6.

ENERLYF will display "ELYF" for some time and it will disappear.

Percentage of time AC remains OFF.

Total Run Time of device including AC & FAN.

Only AC Run Time.

Note: This figures are indicative only for the purpose of visual demonstration. It has no relavance with actual savings.